印染废水RO浓水水质分析

以江苏某印染废水处理厂反渗透（RO）浓水为研究对象,采用多种分析手段分析了RO浓水的水质特征.首先采用IC和ICP-MS对水中的无机离子进行了定性和定量分析,采用GC-MS对废水中的半挥发性有机物进行定性和定量分析.结果表明,RO浓水中无机离子以Na⁺、Cl^-和SO₄^2-为主,半挥发性有机物邻苯二甲酸二（2-乙基己）酯（DEHP）为主要成分,其浓度为1.452mg/L.为分析RO浓水中的溶解性有机物（DOM）特征,进一步采用超滤膜分子量分级法和树脂亲疏水分离技术对废水中的DOM进行分离解析,分析了不同组分的溶解性有机碳（DOC）、UV₂₅₄、SUVA含量和分布情况,应用三维荧光光谱对各组分物质进行了定性分析.超滤分级表明,RO浓水中相对分子量<1k的有机物占56.98%,相对分子质量5~10k有机物仅占2.19%,但其芳香化程度较高.树脂分离结果表明,RO浓水中亲水性物质（HPI^*）、疏水性物质（HPO^*）和过渡性物质（TPI^*）的DOC含量差异不大,其中HPO^*的芳香构造化程度最高,含有较多的色氨酸类芳香族蛋白质,而HPI^*中含有较多的溶解性微生物代谢产物类物质.     

Visible-light-driven photocatalytic inactivation of bacteriophage f2 by Cu-TiO2 nanofibers in the presence of humic acid

Pathogenic viruses in drinking water are great threats to public health. Visible-light-driven photocatalysis is a promising technology for virus inactivation. However, the existing photocatalytic antiviral research studies have mostly been carried out in single-component systems, neglecting the effect of natural organic matter, which exists widely in actual water bodies. In this paper, electrospun Cu-TiO₂ nanofibers were prepared as photocatalysts, and their photocatalytic antiviral performance in the presence of humic acid (HA) was comprehensively studied for the first time. The properties of the reaction mixture were measured during the reaction. In addition, the safety, reliability and stability of photocatalytic disinfection in the mixed system were evaluated. The results showed that the virus removal efficiency decreased with the increase of the HA concentration. The type of reaction solution, such as PBS buffer solution or water, did not affect the removal efficiency noticeably. Under acidic conditions, the electrostatic forces between photocatalysts and viruses were strengthened, leading to higher virus removal efficiency. As the reaction time went on, the pH value in the solution increased first and then tended to be stable, the conductivity remained stable, and the dissolved oxygen increased first and then decreased. The safety test showed that the concentration of Cu ions released into the solution was lower than specified by the international standards. No photoreactivation was observed, and the addition of HA significantly reduced the reutilization efficiency of the photocatalysts.     

Development of an extraction method for perchlorate in soils

Perchlorate originates as a contaminant in the environment from its use in solid rocket fuels and munitions. The current US EPA methods for perchlorate determination via ion chromatography using conductivity detection do not include recommendations for the extraction of perchlorate from soil. This study evaluated and identified appropriate conditions for the extraction of perchlorate from clay loam, loamy sand, and sandy soils. Based on the results of this evaluation, soils should be extracted in a dry, ground (mortar and pestle) state with Milli-Q water in a 1 ratio 1 soil ratio water ratio and diluted no more than 5-fold before analysis. When sandy soils were extracted in this manner, the calculated method detection limit was 3.5 microg kg(-1). The findings of this study have aided in the establishment of a standardized extraction method for perchlorate in soil.     

Source identification and trends in concentrations of gaseous and fine particulate principal species in Seoul, South Korea

Ambient measurements were made using two sets of annular denuder system during the four seasons (April 2001 to February 2002) and were then compared with the results during the period of 1996-1997 to estimate the trends and seasonal variations in concentrations of gaseous and fine particulate matter (PM2.5) principal species. Annual averages of gaseous HNO3 and NH3 increased by 11% and 6%, respectively, compared with those of the previous study, whereas HONO and SO2 decreased by 11% and 136%, respectively. The PM2.5 concentration decreased by -17%, 35% for SO4(2-), and 29% for NH4+, whereas NO3- increased by 21%. Organic carbon (OC) and elemental carbon (EC) were 12.8 and 5.98 microg/m(-3), accounting for -26 and 12% of PM2.5 concentration, respectively. The species studied accounted for 84% of PM2.5 concentration, ranging from 76% in winter to 97% in summer. Potential source contribution function (PSCF) analysis was used to identify possible source areas affecting air pollution levels at a receptor site in Seoul. High possible source areas in concentrations of PM2.5, NO3-, SO4(2-), NH4+, and K+ were coastal cities of Liaoning province (possibly emissions from oil-fired boilers on ocean liners and fishing vessels and industrial emissions), inland areas of Heibei/Shandong provinces (the highest density areas of agricultural production and population) in China, and typical port cities (Mokpo, Yeosu, and Busan) of South Korea. In the PSCF map for OC, high possible source areas were also coastal cities of Liaoning province and inland areas of Heibei/Shandong provinces in China. In contrast, high possible source areas of EC were highlighted in the south of the Yellow Sea, indicating possible emissions from oil-fired boilers on large ships between South Korea and Southeast Asia. In summary, the PSCF results may suggest that air pollution levels in Seoul are affected considerably by long-range transport from external areas, such as the coastal zone in China and other cities in South Korea, as well as Seoul itself.     

基于SIL评估的LNG加气站安全仪表系统问题分析及改进建议*

为分析LNG加气站安全仪表系统的功能完备性与可靠性,以3座典型的三级LNG加气站为研究对象,全面开展安全仪表功能辨识、安全完整性等级（SIL）定级与验证,进而提出针对性的改进建议。结果表明:3座LNG加气站的安全仪表系统均存在功能不完备、设备组件缺少失效数据的问题;为满足风险控制要求,三级LNG加气站需设置15个安全仪表功能,其中1个应达到SIL2等级,14个应达到SIL1等级;LNG加气站的安全仪表系统应选用获得功能安全认证的设备组件,并在设计阶段开展SIL评估工作。研究结果可为今后LNG加气站安全仪表系统的设计与管理提供重要参考。     

北京地铁岛式站台噪声的初步研究

为研究北京岛式站台噪声水平及噪声特点,选取了北京地铁2号线和5号线的10个岛式站台进行了实地的测量,从噪声级以及频谱角度对测量结果进行了分析。结果显示,测量时间内的LAeq,max都高于标准限值80dB(A)。使用独立样本t检验的结果得出,2号线与5号线在LAeq以及LAeq,max上不存在显著差异(P>0.05),说明2号线和5号线噪声在相近的水平上。通过噪声频谱的时程曲线也直观的得出列车在进出站过程中噪声级大于80dB(A),无列车通过且不受相反轨道列车影响时的背景噪声在65dB(A)左右,受影响时在70dB(A)左右。倍频程频谱分析得出,地铁站台噪声具有明显的中频特征。进一步分析,2号线和5号线站台都存在若干的主频,其基频和谐频分别为63、250和1kHz。     

Absorption characteristics of potassium carbonate-based solutions with rate promoters and corrosion inhibitors

In this research, absorbents for CO₂ capture were prepared by blending 30 wt% potassium carbonate, 3 wt% of a rate promoter, and 1 wt% of a corrosion inhibitor. Pipecolic acid, sarcosine, and diethanolamine were chosen as rate promoter candidates. Based on a rate promoter screening test for CO₂ loading capacity and absorption rate, pipecolic acid and sarcosine were selected to be used as rate promoters. 1,2,3-benzotriazole and ammonium thiocyanate were chosen as corrosion inhibitors, and they were mixed with a 30 wt% potassium carbonate-based absorbent mixture containing one of the rate promoters. The absorption rates for four absorbent solutions (30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% 1,2,3-benzotriazole, 30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% ammonium thiocyanate, 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% 1,2,3-benzotriazole, and 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% ammonium thiocyanate) were measured, tabulated, and graphically displayed. These types of absorbents can be used for capturing CO₂ under high temperature and pressure conditions, such as those found in coal-fired power plants.     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

Biodegradation of Poly(Aspartic Acid-Itaconic Acid) Copolymers by Miscellaneous Microbes from Natural Water

Poly(aspartic acid-itaconic acid) copolymers (PAI) is a new scale inhibitor for water treatment. Thus, it is necessary to investigate its biodegradability. The biodegradability of PAI was investigated through CO₂ evolution tests under different conditions based on determination of carbon dioxide production. The investigation results showed that the degradation rate of PAI on day 10 and day 28 were respectively 38.7 and 79.5%, indicating that PAI was one kind of easily biodegradable scale inhibitors. With the increase in the content of itaconic acid in copolymerization process, the biodegradability of PAI was significantly reduced. In addition, the high biodegradability might be attributed to the existence of C–N bone-structure and more –COO–. Finally, Cu²⁺ could decrease the degradation percentage and the enzyme inhibition effect of Cu²⁺ was not the linear effect, but the “low-dosage effect”.     

N2O profiles in the enhanced CANON process via long-term N2H4 addition: minimized N2O production and the influence of exogenous N2H4 on N2O sources

Environmental Science and Pollution Research - Production of the greenhouse gas nitrous oxide (N2O) from the completely autotrophic nitrogen removal over nitrite (CANON) process is of growing...